Part Finder

Wilwood D52 Front Caliper Kit - Black Powdercoat

Part #
140-11290-BK
In Stock
Estimated Date of Shipment # 2025-02-23
$441.00
D52 Front Caliper Kit - Black Powder, 2.00 / 2.00" Piston,1.28" Rotor
Wilwood's D52 Front Caliper Kit is a direct bolt-on 2 piston replacement for the factory original single calipers on many 1968-96 GM Passenger Vehicles and Trucks. Forged billet aluminum bodies, stainless steel pistons, and competition style high-temperature seals put an end to the rust, bore pitting, and seal failures that plague the OE caliper design. D52 calipers provide low-maintenance performance and a huge weight savings with high temperature reliability for the street and track. D52 calipers mount in the stock location over stock Rotors, use the original style OE D52 brake pads and an OE 7/16-20 banjo bolt brake line mounting. Calipers can be used with most wheels that clear the OE calipers. The front calipers with 2.00” piston provide 6.28 square inches of piston area per caliper, in order to maintain the original front to rear brake bias and use of the OE master cylinder. Kits contain Wilwood’s hardened slide pins and BP-10 high friction pads. Matching rear calipers are also available for custom installations. Vehicles 1978 & Up (with M10-1.5 banjo bolts) will require new brake lines available below.
More Information
Product Name Wilwood D52 Front Caliper Kit - Black Powdercoat SKU 140-11290-BK
Vendor SKU 140-11290-BK Prop65 Yes
Brand Wilwood Engineering
Write Your Own Review
You're reviewing:Wilwood D52 Front Caliper Kit - Black Powdercoat
Your Rating
Customer Questions
Can you put brake calipers on wrong?
Yes, on some vehicles, the caliper can be installed on the wrong side. Because you can't bleed off the air that builds at the top of the caliper, the bleeder screw will now be on the bottom, and you'll never have a firm pedal.
Why don't my brakes work after adding calipers?
One of the main reasons why your brakes don't work after adding calipers is because you have air in the line and need to bleed the brakes at all four wheels.
What happens if you don't grease calipers?
If all the friction points of your caliper go unlubricated the pads will not slide from side to side easily and you will more likely have pulsing brakes and intermittent brake drag noises. The drag noise is usually more apparent at low speeds.
Can dirty brake fluid cause calipers to stick?
Dirty brake fluid can result in the calipers sticking, cause uneven braking, and even in some cases cause brake failure. It's important to regularly check and maintain your brake fluid to ensure the safety and performance of your vehicle's braking system...
How do you reset a brake caliper?
You can reset your brake caliper by pushing a flat blade screwdriver in between the brake pads and twisting it. This will separate the brake pads and, in turn, push back the pistons to the reset position
Did you find what you were looking for?

There is no Attribute Value.

Compare(0)